How to apply a hair color

Foam dye

Easy-to-use foam type even for beginners.
Apply plenty of foam by hand and gently massage onto your hair to achieve an even finish.

Quasi-drug Hair color for grey coverage

*Read directions carefully for correct usage.
*Never use the product if you have ever experienced irritation using a hair color.
Before each use of this product, perform a skin allergy test 2 days (48 hours) in advance.

Directions

  • 1.Mix the components

    1.Mix the components

    1.Mix the components

  • 2.Squeeze out foam

    2.Squeeze out foam

    2.Squeeze out foam

  • 3.Application

    3.Application

    3.Application

  • 4.Gently lather up the foam

    4.Gently lather up the foam

    4.Gently lather up the foam

  • 5.Check, leave-on, and finish

    5.Check, leave-on, and finish

    5.Check, leave-on, and finish

◆Before using the product
Preparation
●Apply a thin layer of oil-based skin cream on the face along the hairline as well as on the ears and arms to prevent skin staining.
● Make sure to comb the hair to prevent it from tangling.

1.
Mix the components

Make the mixture right before application.
Pour all of solution 1 into solution 2.

Close the white lid, and gently invert the container back and forth at a 180-degree angle until solution is well mixed (repeat approximately 5 times)

Caution!:Do not shake the bottle.
If the fluid bubbles inside the bottle, it will not come out properly as foam.

Remove the flat cap and tightly attach the foamer cap.

2.
Squeeze out foam

Put gloves on.
Hold the bottle upright, squeeze the center of the bottle to dispense a generous amount of foam (about the size of a large egg) onto your palm.

Caution!:Do not tilt the bottle too much.
Doing so may prevent the fluid from coming out as foam.

Caution!:Do not apply runny foam or fluid to the hair.
Doing so may cause the hair dye to drip and get into the eyes.

3.
Application

*This product is not a shampoo.

Make sure to use the recommended amount.
Using less than the recommended amount leads to an inability to cover all the hair and unsatisfactory results.

Caution!:Do not dispense the foam directly on the hair from the bottle. Doing so may result in the foam getting in your eyes or splattering around you.

Apply a generous amount of foam on the roots.

Start with the roots of gray hair.
* Foam may disappear into the hair at the beginning.
Keep applying the foam to let it penetrate into all the hair.

Apply a generous amount of foam on the roots and let it penetrate while roughly sectioning hair at different places.

Roughly part the hair on the back of the head to apply the foam.

4.
Gently lather up the foam

Use your fingers to gently massage the foam on hair so that the foam penetrates the roots.

Key point: keep massaging until the foam becomes creamy foam that is rich, dense, and heavy.

Caution!Pay attention and keep your hair free of tangles.
・Do not rub the hair hard with the palms.
・Do not rub the dye into the hair too hard
after you put your hair up

Wrap your hair with rich and creamy foam.

Key point: Apply plenty of foam to the hairline and other areas with gray hair.

5.
Check, leave-on, and finish

Check before leave-on

Run your fingers through your hair to check if the hair is tangled.

Check if the foam has got on the face, ears, neckline, or arms. Wipe it off immediately with a tissue if it has.

Leave-on

Let it sit for 20 minutes.
Waiting for another 5 to 10 minutes is recommended if your hair is not easily dyed.

Caution!:Rub the dye into the hair again if it appears that the foam may drip.

Finish

After leave-on, rinse off little by little with lukewarm water while running your fingers through your hair.
Rinse well, shampoo twice, and apply the enclosed after color treatment to finish.

Page Top